how to fix whirlpool cabrio washer dr code?

If you own a Whirlpool Cabrio washer, you may have encountered the frustrating DR Error Code at some point. This error code indicates that the machine has been running for three cycles without the door being opened, triggering the error message.

While this error can be a nuisance, the good news is that it is usually easy to fix. In this article, we will guide you through the steps to resolve the Whirlpool Cabrio washer DR Error Code and get your machine back up and running smoothly.

Key Takeaways:

• The DR Error Code on a Whirlpool Cabrio washer occurs when the machine runs for three consecutive cycles without the door being opened.
• To clear the code, open and close the door and restart the cycle. If the error persists, try powering down the unit and starting a new cycle.
• The DR Error Code is often caused by issues with the drainage system, such as clogs, malfunctioning control modules, or wiring problems.
• To troubleshoot the issue, manually drain the water, check the drain hose and filter, and inspect the drain pump and connections for damage or loose connections.
• If necessary, replace the pump or seek professional assistance for control module problems.

Common Causes of the DR Error Code

The DR Error code on a Whirlpool Cabrio washer is often related to issues with the drainage system. Some of the common causes of this error include:

• A clog in the drainage system
• A malfunctioning control module
• Wiring problems between the drain pump and the main controller
• A faulty drainage pump

It’s important to check these components and perform the necessary troubleshooting steps to resolve the DR Error code. By identifying and addressing the underlying cause, you can ensure the proper functioning of your Whirlpool Cabrio washer.

https://www.youtube.com/watch?v=VL_IkACkhIk

Troubleshooting Steps to Fix the DR Error Code

If you are encountering the DR Error code on your Whirlpool Cabrio washer, there are several troubleshooting steps you can take to resolve the issue.

First, manually drain the water from the machine using the emergency drainage door. This can help eliminate any blockage that may be causing the error. Once the water is drained, unplug the washer and let it rest for 10-15 minutes to reset the system.

Next, inspect the drain hose and filter for clogs or damage. Make sure they are properly installed and not obstructed. Additionally, clean the siphon that connects the hosepipe to the sewerage system, as this can also contribute to the DR Error code.

After checking the drainage components, examine the drain pump and its connections for any damage or loose connections. If necessary, replace the pump or seek assistance from a professional repairman. If the issue persists, it may indicate a control module problem, which requires professional help to diagnose and fix.

By following these troubleshooting steps, you can successfully resolve the DR Error code on your Whirlpool Cabrio washer and get your machine back to working properly.